Hi guys,
I'd like to mod some genny carts.
What's the best way to cut them ?
I think it's a dremel but there is so many accessories for this tool...I don't find which wheel I should use !
And the best way to make polish cut ?
Cut the plastic then sand paper or again dremel with an specific accessory ?
I'd like to avoid this kind of ugly cut:
best way to cut cart ?
Moderator: BigEvilCorporation
-
- Very interested
- Posts: 2440
- Joined: Tue Dec 05, 2006 1:37 pm
- Location: Estonia, Rapla City
- Contact:
Sharp knife
Mida sa loed ? Nagunii aru ei saa
http://www.tmeeco.eu
Files of all broken links and images of mine are found here : http://www.tmeeco.eu/FileDen
http://www.tmeeco.eu
Files of all broken links and images of mine are found here : http://www.tmeeco.eu/FileDen
-
- Very interested
- Posts: 2984
- Joined: Fri Aug 17, 2007 9:33 pm
-
- Very interested
- Posts: 2440
- Joined: Tue Dec 05, 2006 1:37 pm
- Location: Estonia, Rapla City
- Contact:
You can use dremel or file to get the big bits out, and then use knife to get really nice looking results. Nice sharp knife will make cuts that look like it was so from beginning.
Mida sa loed ? Nagunii aru ei saa
http://www.tmeeco.eu
Files of all broken links and images of mine are found here : http://www.tmeeco.eu/FileDen
http://www.tmeeco.eu
Files of all broken links and images of mine are found here : http://www.tmeeco.eu/FileDen
-
- Very interested
- Posts: 2984
- Joined: Fri Aug 17, 2007 9:33 pm
Yeah, use the knife for very fine trimming at the end if needed to make it all nice and neat and clean.TmEE co.(TM) wrote:You can use dremel or file to get the big bits out, and then use knife to get really nice looking results. Nice sharp knife will make cuts that look like it was so from beginning.